Royal-consumer-information-products G31 Manuel d'utilisateur télécharger pdf (Page 2)

'(6&5,37,21

The Super Hot Toaster has a single aerated burner, the design of which produces two parallel ribbons of flame that

run across the front of the fire bed. The rear ribbon of flame is ignited first and the front ribbon cross lights from it

instantaneously. A single gas control selects ignition (pilot only) and can be turned anticlockwise to select a high

rate and then a reduced input at the maximum rotation. For extra safety the control is designed so that gas cannot

be allowed to reach the burner until pilot ignition has been proven. A separate push button piezo igniter provides

pilot ignition.

A Flame Supervision Device (FSD) is fitted. This ensures that if the pilot goes out for any reason (including being

turned off), the gas flow to the burner is cut off until the full lighting procedure is repeated. The oxy-pilot or

O.D.S. will cause the appliance to ‘shut off’ in the event of continued spillage occurring under hazardous or

blocked flue conditions. The burner assembly is fixed to the base of the radiant box which also includes a fire back

made of ceramic fibre, this forms an insulating surface to reflect heat into the fire bed, raising its temperature and

increasing the amount of heat radiated into the room. A decorative brass trim completes the front face of the

appliance.

There are two types of front and fret available for this appliance; these have perforated frets to allow air to be

entrained into the fire bed to ensure clean combustion. The optional fire fronts and frets are listed in figure 11. If

other Fronts and Frets are to be used they must have a minimum open area in the fret of 20 square centimetres and

60 square centimetres in the Front, as shown in figure 11.

,03257$17127(6

The Super Hot Toaster is a decorative fuel effect appliance designed and manufactured to the requirements of

the British Standards Institution BS 5258 Part 12: 1990 and is for use on Propane Gas only

All gas appliance installations must be installed by a competent person in accordance with the current Gas

Safety (Installation and Use) Regulations 1994 (as amended) or the rules in force and in accordance with the

attached Installation Instructions, failure to do so could lead to prosecution.

Areas of this appliance will become hot after prolonged running and it is recommended that for the protection of

the very young, elderly and infirm a fireguard conforming to BS 6539 or BS 6778 be used.

Care should be taken to prevent any damage being caused to surrounding soft furnishings or decor e.g. many

embossed vinyl wall coverings may become discoloured if located too close to the appliance. Clearances required

for combustible shelves are shown on page 3.

This product uses fuel effect pieces, gaskets and insulation material containing Refractory Ceramic Fibre

(RCF), which are man-made vitreous silicate fibres. Excessive exposure to these materials may cause temporary

irritation to eyes, skin and respiratory tract; consequently, it makes sense to take care when handling these

articles to ensure that the release of dust is kept to a minimum.

It is recommended that a competent person should sweep the chimney or flue annually and the appliance checked

for spillage (smoke test) and that there is no excessive deposit of soot.

The curing effect of heating the coals will cause an initial odour that, although not harmful, may require

additional ventilation until the odour has disappeared. This appliance will run on Full for approximately 2.2

hours on one kilogram of gas.

72/,*+77+($33/,$1&(

Remove the fret (controls cover), to gain access to the controls

Press and turn the gas control until the indicator mark is opposite to IGN. Keep the control fully depressed.

Press and release the ignition button. Check that the pilot flame has lit at all ports. Keep the gas control

depressed for a further 20 seconds. Release the gas control and check the pilot remains alight.

Depress the gas control slightly and turn fully anticlockwise until the indicator mark is opposite the small

flame symbol. The burner will now ignite from the pilot assembly and run at the low rate.

Depress the gas control slightly and turn clockwise until the indicator mark is opposite to the large flame

symbol. The burner will now run at its maximum rate.

To turn the appliance ‘off’, return the control to the ‘off’ position.

If for any reason the fire cuts out, return the control knob to the `off’ position and wait 3 minutes before re-

lighting.

1 2 3 4 5 6 7 ... 14 15

SUPER HOT TOASTER 1

Commentaires sur ces manuels

Pas de commentaire

Royal-consumer-information-products G31 Manuel d'utilisateur Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Four Royal-consumer-information-products G31